How To Repair A Cut Power Cord

How to Repair a Cut Power Tool Cord

Attempt this DIY set up before you buy a new cord!

FH13JUN_REPCRD_01-2 Family Handyman

Ability tool cords that get accidentally cutting or hacked can exist permanently repaired in minutes with heat shrinkable tubing and a soldering gun.

You might as well like: TBD

Saving a power cord

Photo i: Slit and skin the jacket

Slice effectually the outer jacket nigh 3 in. on both sides of the damage. So slit the jacket down the eye and peel it off.

Photo two: Strip, twist and solder

Strip insulation off each wire. Then twist the strands together and solder. Solder each splice.

Photograph 3: Cover and compress

Slide the shrinkable tubing over the splices and outer jacket. Shrink the tubing with a heat gun.

Got a nicked or cut ability tool string? Nosotros'll show you how to restore it to "almost new" condition. You'll need heat shrinkable tubing in both pocket-size and large diameters, a soldering gun and rosin-core solder, a utility knife, heat gun and wire strippers.

Start past removing a half dozen-in. section of the outer jacket (Photo ane). Save it for later use. Then cut all the wires and the reinforcement cord. Slide a piece of large-diameter estrus shrinkable tubing onto the string and push information technology out of the fashion for now.

Slide a small slice of rut shrinkable tubing onto each wire. Stagger the splices and solder (Photo 2). Allow the solder cool, then slide the tubing over each splice and shrink it with a heat gun.

Terminate the job by reinstalling the outer jacket. So cover the entire patched area with the big tubing and shrink it (photo 3).